- Mon Dec 05, 2022 8:45 am
#237488
I am confident I am missing something obvious.
I have recently received:
DEV-18710 MicroMod mikroBUS Carrier Board[/list]
DEV-17713 SparkFun MicroMod STM32 Processor
CAB-09215 AVR Programming Cable
PGM-19104 MIKROE mikroProg for STM32
PRT-15363 Header - 2x5 Pin (Female, 1.27mm)
PRT-15362 Header - 2x5 Pin (Male, 1.27mm)
After receiving the kit and reading the 'Getting Started' guide a few dozen times I followed these steps below:
I have soldered the 2x5 header to the jtag position on the Micromod carrier board
Installed the STM32 processor
Tested my connections about 10 times
Connected the board to power via a USB C cable
Connected the mikroProg via the jtag connector
I get the indicator light on the mikroProg that I have USB connection. I see the USB connection on the computer. But I never see the 'Active' light or 'Data' light.
I have not been able to get either MikroProg Suite or Codegrip to recognize the microprocessor. I believe I've double checked that I have the ST link drivers but maybe missing something.
I'm feeling a bit over my head, any help is appreciated.
I have recently received:
DEV-18710 MicroMod mikroBUS Carrier Board[/list]
DEV-17713 SparkFun MicroMod STM32 Processor
CAB-09215 AVR Programming Cable
PGM-19104 MIKROE mikroProg for STM32
PRT-15363 Header - 2x5 Pin (Female, 1.27mm)
PRT-15362 Header - 2x5 Pin (Male, 1.27mm)
After receiving the kit and reading the 'Getting Started' guide a few dozen times I followed these steps below:
I have soldered the 2x5 header to the jtag position on the Micromod carrier board
Installed the STM32 processor
Tested my connections about 10 times
Connected the board to power via a USB C cable
Connected the mikroProg via the jtag connector
I get the indicator light on the mikroProg that I have USB connection. I see the USB connection on the computer. But I never see the 'Active' light or 'Data' light.
I have not been able to get either MikroProg Suite or Codegrip to recognize the microprocessor. I believe I've double checked that I have the ST link drivers but maybe missing something.
I'm feeling a bit over my head, any help is appreciated.
A Bill from Atlanta