- Fri Apr 23, 2010 8:23 pm
#99255
Trying to use this fuse calculator for the atmel168:
http://www.engbedded.com/fusecalc/
But it's damn confusing
I'm trying to follow along with this tutorial:
http://www.sparkfun.com/commerce/tutori ... ials_id=95
But i'm getting different hex values than the tut shows.
If I read it right the low fuse bit should be 11100110, which is, according to the tut
0xE6, for the 16Mhz external oscillator. I suppose I could be reading this wrong.
Anyway when type it in a get 0x19. Using the manual fuse bit one.
I can't seem to figure out the top fuse bit calculator on that site.
I don't see an EXT Crystal Osc16Mhz choice on the drop down bar.
This is all kinda new to me, so forgive me if this is one of those stupid questions
newbies always asks.
http://www.engbedded.com/fusecalc/
But it's damn confusing
I'm trying to follow along with this tutorial:
http://www.sparkfun.com/commerce/tutori ... ials_id=95
But i'm getting different hex values than the tut shows.
If I read it right the low fuse bit should be 11100110, which is, according to the tut
0xE6, for the 16Mhz external oscillator. I suppose I could be reading this wrong.
Anyway when type it in a get 0x19. Using the manual fuse bit one.
I can't seem to figure out the top fuse bit calculator on that site.
I don't see an EXT Crystal Osc16Mhz choice on the drop down bar.
This is all kinda new to me, so forgive me if this is one of those stupid questions
newbies always asks.