- Wed Apr 02, 2008 5:38 pm
#45723
Hello all,
I have followed the walk-through and it appears to me that I have everything hooked up correctly:
On my transmitter, I can see 1400 baud at DATA coming in from the microcontroller. I also have regulated 6v at VCC.
My receiver is being powered by a 5v 1A switching power supply. I see the correct levels at the +5V pins. I placed the transmitter about 20 feet away. I have connected a scope to my receiver and all I see is noise. I do not see a change in the signal whether or not I am transmitting.
What am I doing wrong?
I have followed the walk-through and it appears to me that I have everything hooked up correctly:
On my transmitter, I can see 1400 baud at DATA coming in from the microcontroller. I also have regulated 6v at VCC.
My receiver is being powered by a 5v 1A switching power supply. I see the correct levels at the +5V pins. I placed the transmitter about 20 feet away. I have connected a scope to my receiver and all I see is noise. I do not see a change in the signal whether or not I am transmitting.
What am I doing wrong?