- Tue Dec 04, 2007 12:52 pm
#39034
I'm trying to make a board for the luxeon rebel series LED's very similar to http://www.sparkfun.com/commerce/produc ... ts_id=8475
a few questions :
- anyone know a source of cheap mounting boards specifically for the rebel series led's?
- in eagle what can use to define a aluminum layer like the under surface of the above mentioned board?
- will BatchPCB charge extra for this layer?
a few questions :
- anyone know a source of cheap mounting boards specifically for the rebel series led's?
- in eagle what can use to define a aluminum layer like the under surface of the above mentioned board?
- will BatchPCB charge extra for this layer?