- Tue Apr 10, 2018 4:08 am
#198909
Hi all!
I am currently working on the Sparkfun nRF52832 breakout board and am having various problems regarding the same. I am able to flash the breakout board via the Nordic nRF52 Development Kit refering to the instructions on the link --> https://learn.sparkfun.com/tutorials/nr ... okup-guide.
I have previously flashed the same code into the DK and have been able to view the log through the pins I assigned for UART communication. However, in the case of the sparkfun breakout board, I am not able to view the log and hence can't be sure if the nrfSDK 15.0 example code ble_app_att_mtu_throughput is working correctly on it.
The connections I did with the 13 and 14 pins assigned as TX and RX pins respectively(USB to TTL -> Sparkfun nRF52832 breakout board):
3.3V --> VCC, RX --> 13, TX --> 14, GND --> GND
For the debugging(nRF52 Development Kit -> Sparkfun nRF52 Breakout board):
VTG -->3V3, SWDIO --> D, SWDCLK --> C, RESET --> RESET, GND DETECT --> GND
Anyone has had the same problem or anyone knows whats wrong or able to suggest changes? Any help is highly appreciated.
I am currently working on the Sparkfun nRF52832 breakout board and am having various problems regarding the same. I am able to flash the breakout board via the Nordic nRF52 Development Kit refering to the instructions on the link --> https://learn.sparkfun.com/tutorials/nr ... okup-guide.
I have previously flashed the same code into the DK and have been able to view the log through the pins I assigned for UART communication. However, in the case of the sparkfun breakout board, I am not able to view the log and hence can't be sure if the nrfSDK 15.0 example code ble_app_att_mtu_throughput is working correctly on it.
The connections I did with the 13 and 14 pins assigned as TX and RX pins respectively(USB to TTL -> Sparkfun nRF52832 breakout board):
3.3V --> VCC, RX --> 13, TX --> 14, GND --> GND
For the debugging(nRF52 Development Kit -> Sparkfun nRF52 Breakout board):
VTG -->3V3, SWDIO --> D, SWDCLK --> C, RESET --> RESET, GND DETECT --> GND
Anyone has had the same problem or anyone knows whats wrong or able to suggest changes? Any help is highly appreciated.