- Sat Apr 15, 2017 6:25 pm
#194382
Greetings. I have the ESP8266 Thing I am working on and It really seems to be hit and miss with programming.
I am powering it with a hefty source that could easily provide more than one amp.
most of the times when I'm flashing the device I get this
warning: espcomm_sync failed error:
espcomm_open failed error:
espcomm_upload_mem failed error:
espcomm_upload_mem failed
I then started attaching pin 0 to ground and every now and then It worked.
I've done this while playing with the on/off micro slider switch but ti doesn't seem to do anything. Does anyone have a good step by step process for reliably flashing these things? This is getting very annoying and almost seems hit and miss
Thanks
Bill
I am powering it with a hefty source that could easily provide more than one amp.
most of the times when I'm flashing the device I get this
warning: espcomm_sync failed error:
espcomm_open failed error:
espcomm_upload_mem failed error:
espcomm_upload_mem failed
I then started attaching pin 0 to ground and every now and then It worked.
I've done this while playing with the on/off micro slider switch but ti doesn't seem to do anything. Does anyone have a good step by step process for reliably flashing these things? This is getting very annoying and almost seems hit and miss
Thanks
Bill