- Wed Oct 09, 2013 2:04 am
#164301
Hi, i had bought a Venus GPS with SMA Connector and an antenna GPS Embedded SMA as shown below:
https://www.sparkfun.com/products/11058
https://www.sparkfun.com/products/177
i connected them to my Arduino UNO:
-3.3v power supply to 3.3v of Venus GPS,
-Tx0 pin of Venus GPS to RX of Arduino UNO,
-GND to GND
-3.3v power supply to VBAT.
However, the red led of my Venus GPS did light up but there is no blinking and this is what i get in my serial monitor:
Lat: 0000.0000N Long: 00000.0000E.
(i got my code from the tutorial of Simon Monk).
can anyone tell me what's wrong with my circuit? thanks!
https://www.sparkfun.com/products/11058
https://www.sparkfun.com/products/177
i connected them to my Arduino UNO:
-3.3v power supply to 3.3v of Venus GPS,
-Tx0 pin of Venus GPS to RX of Arduino UNO,
-GND to GND
-3.3v power supply to VBAT.
However, the red led of my Venus GPS did light up but there is no blinking and this is what i get in my serial monitor:
Lat: 0000.0000N Long: 00000.0000E.
(i got my code from the tutorial of Simon Monk).
can anyone tell me what's wrong with my circuit? thanks!