DEV 16832 set up and connection

DEV 16832 set up and connection#241800

By PKESARL - Fri Jun 09, 2023 4:15 pm

- Fri Jun 09, 2023 4:15 pm #241800

Hi,
I am trying to set up the DEV 16832. I put the SD card and connected the USB C cable and opened serial monitor in arduino IDE. I am getting symbols as data. I attached picture. I am not able to figure out the issue.

You do not have the required permissions to view the files attached to this post.

Re: DEV 16832 set up and connection#241802

By YellowDog - Fri Jun 09, 2023 6:16 pm

- Fri Jun 09, 2023 6:16 pm #241802

Check that your baud rate is correct.

Re: DEV 16832 set up and connection#241846

By PKESARL - Tue Jun 13, 2023 9:20 am

- Tue Jun 13, 2023 9:20 am #241846

I tried all baud rates, i am still getting the same error

Re: DEV 16832 set up and connection#241847

By TS-Russell - Tue Jun 13, 2023 10:28 am

- Tue Jun 13, 2023 10:28 am #241847

Double check the COM port and board selected https://learn.sparkfun.com/tutorials/op ... figuration, ensure newline is selected, change the baud rate to 115200

Re: DEV 16832 set up and connection#241964

By PKESARL - Mon Jun 19, 2023 7:55 am

- Mon Jun 19, 2023 7:55 am #241964

That worked! thank you

SparkFun Forums