Battery babysitter + 6000mAh

Have questions about a SparkFun product or board? This is the place to be.

Moderator: phalanx

Post Reply
Posts: 1
Joined: Mon Oct 09, 2017 1:40 pm

Battery babysitter + 6000mAh

Post by rickard.eklof » Mon Oct 09, 2017 1:50 pm


I'm building a project which needs to be battery powered for quite some time without recharging. I also want a battery monitor that will tell me the status of the battery.
I found these two parts:

* Battery babysitter (
* LiIo Battery 6Ah (

I could not find any answer if these two components would work together since the Battery is 3-cell and the babysitter states "charging cingle-cells". I've read some article about balanced loading would make it OK to charge them - so I'm not sure what the answer is.

Q1. Can these two parts be used together? (Both charging and monitoring)
Q2. If not, are there alternatives that suit my requirements?


Posts: 4
Joined: Sun Oct 08, 2017 11:56 am

Re: Battery babysitter + 6000mAh

Post by TCIII » Thu Oct 12, 2017 10:17 am

Hi Richard,
The battery you want to use has a nominal voltage of 3.7V (single LiPo cell). There are three single cell 2,000 mahr LiPo batteries wired in parallel in the battery case to provide a 6,000 mahr output of 3.7v. It will definitely work with the Battery Babysitter.

Post Reply