Error! on open scale board

Have questions about a SparkFun product or board? This is the place to be.

Moderators: phalanx, TS-Tim

Post Reply
Posts: 1
Joined: Sat Aug 12, 2017 5:03 pm

Error! on open scale board

Post by terryb » Sat Aug 12, 2017 5:26 pm

hooked wiring up per documentation:
hooked up the four wires from new load cell
red to E+
black to E-
white to A-
green to A+
shield to shield
downloaded and installed the drivers
plugged in the board and windows 7 reports com port working on Com: 3
started a hyper terminal 9600 8 N 1
blue light flashes a few times then stays on

Terminal software reports reports:

Serial Load Cell Converter version 1.0
By SparkFun Electronics
No remote sensor found
Minimum time between reports: 488
Press x to bring up settings

Any ideas on why I get the ERROR: No remote sensor found?

thanks Terry

Post Reply