- Sat Jul 23, 2016 1:15 pm
#190809
Hello everybody,
I need an help with the hookup of the Led Tactile Button Breakout: https://www.sparkfun.com/products/10467 ... dd5c8b4568
it is not clear to me how to connect the wires to the x-OSC microcontroller board I am using
(http://www.x-io.co.uk/products/x-osc/). Differently from Arduino, this board does not allow for programming...
I have connected the A to voltage, C to pulldown (10k resistor) and then to GND. Then I connect B1 and B2 to the inputs of the board to read the status od the button.
In this way the led is always on regardless of the status of the button, and I don't get any variation of the input values of the board.
What I am doing wrong? And how/where I connect B1 and B2?
Thanks in advance
I need an help with the hookup of the Led Tactile Button Breakout: https://www.sparkfun.com/products/10467 ... dd5c8b4568
it is not clear to me how to connect the wires to the x-OSC microcontroller board I am using
(http://www.x-io.co.uk/products/x-osc/). Differently from Arduino, this board does not allow for programming...
I have connected the A to voltage, C to pulldown (10k resistor) and then to GND. Then I connect B1 and B2 to the inputs of the board to read the status od the button.
In this way the led is always on regardless of the status of the button, and I don't get any variation of the input values of the board.
What I am doing wrong? And how/where I connect B1 and B2?
Thanks in advance