- Fri Jul 22, 2016 11:21 pm
#190799
Hi All,
I have following doubts, please clear it.
1) when a signal is considered as High Speed signal?
2) when impedance matching becomes more important? How to find such signals?
3) when routing, is it necessary to keep the length of the programming lines same on PCB always?
Thanks and regards
I have following doubts, please clear it.
1) when a signal is considered as High Speed signal?
2) when impedance matching becomes more important? How to find such signals?
3) when routing, is it necessary to keep the length of the programming lines same on PCB always?
Thanks and regards