- Thu Apr 28, 2016 6:06 am
#189600
Hi everyone, i need a solution.
I completed drawing polygon, i named GND to both top layer and bottom layer, then i clicked ratsnest tool,however, the top layer plane didn't appear.
Why does that happen?
This is the board.
http://i.stack.imgur.com/8JW7a.png
if you want to see the .brd and .sch files.
https://www.dropbox.com/s/15f0yvmyquhrb ... t.brd?dl=0
https://www.dropbox.com/s/utokm8y9g8tas ... t.sch?dl=0
i asked the same question here but i still couldn't figure out the problem.
http://electronics.stackexchange.com/qu ... 652_230936
I completed drawing polygon, i named GND to both top layer and bottom layer, then i clicked ratsnest tool,however, the top layer plane didn't appear.
Why does that happen?
This is the board.
http://i.stack.imgur.com/8JW7a.png
if you want to see the .brd and .sch files.
https://www.dropbox.com/s/15f0yvmyquhrb ... t.brd?dl=0
https://www.dropbox.com/s/utokm8y9g8tas ... t.sch?dl=0
i asked the same question here but i still couldn't figure out the problem.
http://electronics.stackexchange.com/qu ... 652_230936