- Thu Mar 10, 2016 11:51 pm
#188625
Hi,
I'm getting 3 Eagle overlap errors while trying to route a line through a MCP23017ML. It's a QFN package and I'm going through the center heat pad to connect some GND pins together (pin 11-13 + 6 are all GND so I made them go through the center). It seems like a reasonable thing to do, but it's not exactly happy about it. I know that I can approve the errors, but wanted to check if I can do this or if I would be best to route those lines around the chip
Thanks,
Chris
I'm getting 3 Eagle overlap errors while trying to route a line through a MCP23017ML. It's a QFN package and I'm going through the center heat pad to connect some GND pins together (pin 11-13 + 6 are all GND so I made them go through the center). It seems like a reasonable thing to do, but it's not exactly happy about it. I know that I can approve the errors, but wanted to check if I can do this or if I would be best to route those lines around the chip
Thanks,
Chris