- Wed Apr 29, 2015 11:20 pm
#181648
Hello all! First of all sorry for my english.
I am creating pcb with RJ45 modules like this
There are 2 modules, each contain 8 RJ45 connectors, every of them need to be connected by parallel by bus, like in this schema:
Eagle generated next tracing:
I think this is so complex design. If it possible and will be wonderfull to make it more simple.
Thank you a Lot!
Leo.
I am creating pcb with RJ45 modules like this
There are 2 modules, each contain 8 RJ45 connectors, every of them need to be connected by parallel by bus, like in this schema:
Eagle generated next tracing:
I think this is so complex design. If it possible and will be wonderfull to make it more simple.
Thank you a Lot!
Leo.