- Fri Apr 17, 2015 9:54 am
#181306
Thanks for the offer to look at the cad files. They are attached.
Several things come to mind:
-I have less than seven layers, because the top layer does not have copper and the bottom layer does not have silks.
-The file extensions are not what I expected to see. Are they correct?
-I am using ViewPlot for my viewer.
--I have not seen a layer that I think is for the drill holes. How do I confirm them?
--How do I confirm that I am using 24leading?
How do I communicate to the board house that I am using gerb274x and 24leading ?
Thanks, again!
Several things come to mind:
-I have less than seven layers, because the top layer does not have copper and the bottom layer does not have silks.
-The file extensions are not what I expected to see. Are they correct?
-I am using ViewPlot for my viewer.
--I have not seen a layer that I think is for the drill holes. How do I confirm them?
--How do I confirm that I am using 24leading?
How do I communicate to the board house that I am using gerb274x and 24leading ?
Thanks, again!
You do not have the required permissions to view the files attached to this post.