SparkFun Forums 

Where electronics enthusiasts find answers.

Have questions about a SparkFun product or board? This is the place to be.
By billtylerjr
Has anyone been able to make the screen on the Edison OLED (DEV-13035) block work?
I have been trying to use the code from the pong example, the buttons and joystick work fine but the screen doesn't seem to work at all.

The setup is oled -> base -> edison.
I am powering everything from the console port.
I measure 4 volts at the power ports under the screen.

Any advice or suggestions before i pry the screen off to test the pins?