SparkFun Forums

[idelaney]

I have a RN52-I/RM on a Sparkfun Breakout board. I can put power to the board, connect to it over the UART, put it in command mode and talk to it over the serial port. Now that I can set up the chip and pair it with my iPhone, what do I need to do to detect incoming calls to the phone? I've been through the command guide and I can see how to establish a call, and connect an incoming call, but nowhere do I see a way to detect an incoming call or count the number of rings.

Can anyone tell me how I go about doing this, or point me to a reference or other information source?

Thank you.