SparkFun Forums 

Where electronics enthusiasts find answers.

Questions relating to designing PCBs
By ilan.lupu1
#171845
hi
what is the minimum distance needed for a 0.4\0.2 component to the v-cut line ?
same question for 0.2\0.1 component

thanks
ilan
By InactiveUser001
#171925
Depends what component it is.

If its a COG ceramic cap then I'd say 5mm to prevent stress when descoring.
Otherwise its good practice to keep as clear as possible, about 1mm should do.

Depends on your descoring methods & equipment.