- Wed Mar 26, 2014 8:20 pm
#169801
I want to use a breakout board in my design, and I have the sch & brd files for the breakout, but is there a way to convert the entire breakout to a library part?
If not, is there a good way to check for clearances? The pin locations are fine, but I'd like to see where the board will end up when soldered on. It would also be nice to be able to position standoff holes.
Thanks.
If not, is there a good way to check for clearances? The pin locations are fine, but I'd like to see where the board will end up when soldered on. It would also be nice to be able to position standoff holes.
Thanks.