- Wed Feb 20, 2013 1:24 pm
#155885
Hi, everybody. I'm working on my first PCB for a class at school and am using a couple of PFETS (http://www.ti.com/product/csd25401q3) to switch on and off LEDs with total current needs of 10A. Since the pins are so small and since I'd like to use the basic 1 oz. of copper, I've been advised to use a copper pour for the source and drain pins. I've gathered from googling that copper pour is just a plane of copper... how would I go about making this happen in Eagle? Quick googling isn't turning up anything helpful. Thanks in advance!