SparkFun Forums 

Where electronics enthusiasts find answers.

Tips and questions relating to the GPS modules from SFE
By benkasmi
#50321
Hi everybody

I tried this simple script that output a text through the serial port

I used the commands:


at#escript="test.py"

at#reboot


after the module rebooted the script starts running and the text message is captured on hyperterminal

PROBLEM IS:

NO matter what I set the DTR switch to on the SparkFun RS232 board the script starts running
I tried both DTR LOW and DTR HIGH

I can not do anything with the module now

Any help would be appreciated
Thanks everybody
By velocet
#50551
AT#STARTMODESCR would be a good place to start.

Get yourself a copy of RSTERM from www.roundsolutions.com/techdocs

Hope this helps.