It seems that I can associate with either access point, but I cannot get DHCP information from either. After the successful association, the GSX reports "DHCP: Start" and that's it. I stay associated, but no IPs are passed to the module. If I assign an IP, gateway, mask, etc. From the GSX standpoint it appears that I'm connected and the module says it is listening on port 2000. However, I am unable to connect to the module or make outgoing connections from the module. That leads me to believe that it really isn't connected.
I have run out of ideas. Has anyone seen this before and found out what the problem is?
Here is some of the output from TerraTerm along with some comments:
--after factory RESET and set wlan join 0 get everything Beacon=100 Probe=5 OPEN=*OPEN* CLOSE=*CLOS* REMOTE=*HELLO* FlushSize=64 MatchChar=0 FlushTimer=10 IdleTimer=0 CmdChar=$ IF=UP DHCP=ON IP=0.0.0.0:2000 NM=255.255.255.0 GW=0.0.0.0 HOST=0.0.0.0:2000 PROTO=TCP, MTU=1460 FLAGS=0x7 BACKUP=0.0.0.0 DNS=0.0.0.0 Name=server1 Backup=backup2 FTP=184.108.40.206:21 File=wifly-GSX.img User=roving Pass=Pass123 SSID=roving1 Chan=0 ExtAnt=0 Join=0 Auth=OPEN Mask=0x1fff Rate=12, 24 Mb Linkmon=0 Passphrase=rubygirl SleepTmr=0 WakeTmr=0 Trigger=0x1 Autoconn=0 IoFunc=0x0 IoMask=0x20f0 PrintLvl=0x1 TimeEna=0 TIMEADR=220.127.116.11:123 Zone=7 Baudrate=9600 Flow=0x0 Mode=0x0 JoinTmr=1000 Replace=0x24 DeviceId=WiFly-GSX Password= BCAST=255.255.255.255:55555 Interval=0x7 <2.15>scan <2.15> SCAN:Found 1 Num SSID Ch RSSI Sec MAC Address Suites 1 dd-wrt 03 -35 Open 00:14:bf:09:95:e9 104 4 join # 1 Auto-Assoc dd-wrt chan=3 mode=OPEN SCAN OK Joining dd-wrt now.. <2.15> Associated! DHCP: Start (nothing is returned, even after several minutes) show net SSid=dd-wrt Chan=3 Assoc=OK Rate=12, 24Mb Auth=OK Mode=OPEN DHCP=FAIL Time=OK Links=1 <2.15>show connection 8333