- Sat Jan 07, 2006 3:04 pm
#8981
Now to start my 3rd topic on this module... Hopefully my last, but that's doubtful.
I am trying to figure out the power supply for this little bugger. The manual calls for 4.5-6.5VDC, but does not elaborate any more on power supply requirements. On my board I have a very noisy 6V supply. It has 18 motors connected to it that are constantly pulsing on and off. Is this suitable?
I thought about the possibility of running the 6V through something like a 5V LDO and then filtering the 5V signal. Would that be an improvement, or will the EM-406 module care about the noisy supply line?
Thanks!
I am trying to figure out the power supply for this little bugger. The manual calls for 4.5-6.5VDC, but does not elaborate any more on power supply requirements. On my board I have a very noisy 6V supply. It has 18 motors connected to it that are constantly pulsing on and off. Is this suitable?
I thought about the possibility of running the 6V through something like a 5V LDO and then filtering the 5V signal. Would that be an improvement, or will the EM-406 module care about the noisy supply line?
Thanks!