- Sat Jul 04, 2009 11:10 pm
#76345
DC Barrel Power Jack
(http://www.sparkfun.com/commerce/produc ... cts_id=119)
This jack has three flat prongs but the Eagle library produces circular holes that are too small. Is there any way to make an elongated-through hole in Eagle to match the prongs?
Is there an actual problem with the Eagle library or am I doing something incorrectly? (I am still new at this.)
(http://www.sparkfun.com/commerce/produc ... cts_id=119)
This jack has three flat prongs but the Eagle library produces circular holes that are too small. Is there any way to make an elongated-through hole in Eagle to match the prongs?
Is there an actual problem with the Eagle library or am I doing something incorrectly? (I am still new at this.)