- Thu Jun 12, 2008 11:58 am
#50134
Hello Fellow Sparkfun Forum Members!
I'm looking for someone that is decent or good with EAGLE.
I have some Gerber Files. That need about like 3 minutes worth of editing.
I need the following edited.
First you need to remove the extra drill holes from the design that are sitting off to the side of the board.
Second you need to have both the bottom and top layers in the same place - not one beside the other.
Third it looks like somehow you have a negative image of the bottom - this needs fixed as well.
http://rapidshare.com/files/121993310/T ... z.zip.html
I'm looking for someone that is decent or good with EAGLE.
I have some Gerber Files. That need about like 3 minutes worth of editing.
I need the following edited.
First you need to remove the extra drill holes from the design that are sitting off to the side of the board.
Second you need to have both the bottom and top layers in the same place - not one beside the other.
Third it looks like somehow you have a negative image of the bottom - this needs fixed as well.
http://rapidshare.com/files/121993310/T ... z.zip.html