- Mon Nov 19, 2007 5:20 am
#38281
Hey
I want to prototype a flexible pcb for an adxl-330 based tilt sensor and use the reflow skillet technique. I was thinking of a flexible pcb with a stiffened section for the chip and then a flexible strip for all the connections to a motherboard.
Has anyone had experience with flexible pcbs in the skillet?
Also what about tips on connectors for the flexible pcb to motherbaord connection?
thanks
rob
I want to prototype a flexible pcb for an adxl-330 based tilt sensor and use the reflow skillet technique. I was thinking of a flexible pcb with a stiffened section for the chip and then a flexible strip for all the connections to a motherboard.
Has anyone had experience with flexible pcbs in the skillet?
Also what about tips on connectors for the flexible pcb to motherbaord connection?
thanks
rob