- Fri Oct 12, 2007 1:29 am
#36351
Maybe some of you remember my problems with the MLF32 and traces I had. That problem was solved, but I run into a new problem.
I had to add a ground to my schematic. No problem of course, but when I switch to the board layout, the new ground doesn't show up.
I need to make a ground path under the mlf32 chip. What are normally the steps to do this?
JD
I had to add a ground to my schematic. No problem of course, but when I switch to the board layout, the new ground doesn't show up.
I need to make a ground path under the mlf32 chip. What are normally the steps to do this?
JD