- Fri Mar 24, 2023 9:40 am
#239898
I'm struggling to get the STM32 board to show up in Arduino IDE. I have it connected via a quality USB-C cable, it's in bootloader mode (or should be), the blue LED on the board is *always* dimly lit. Even power cycling the board and pressing the RESET button repeatedly doesn't disable that LED.
One quirk is occasionally I'll see a macOS prompt to allow access to this "accessory". This prompt literally disappears before I have the chance to hit "allow".
Any ideas?
One quirk is occasionally I'll see a macOS prompt to allow access to this "accessory". This prompt literally disappears before I have the chance to hit "allow".
Any ideas?