- Sat Mar 06, 2021 11:32 pm
#223742
Hello!
I'm adding support for the MicroMod nRF52840 Processor to CircuitPython. I was hoping to find someone that could let me know which USB PIDs would be acceptable to use. I took a nod from the sparkfun_nrf52840_mini board that is already supported in CircuitPython, and have created my PRs using 0x1B4F (SparkFun's) VID, but I'd still like to get some PIDs so as to not accidentally collide with anything else!
I'd need one for the CircuitPython device itself, and two for the UF2 bootloader modes (One is for the regular UF2 bootloader, and the other is for the "CDC Only" UF2 bootloader mode.
If I'm barking up the wrong tree here, just tell me where to point my next yip!
Thanks a bunch!
I'm adding support for the MicroMod nRF52840 Processor to CircuitPython. I was hoping to find someone that could let me know which USB PIDs would be acceptable to use. I took a nod from the sparkfun_nrf52840_mini board that is already supported in CircuitPython, and have created my PRs using 0x1B4F (SparkFun's) VID, but I'd still like to get some PIDs so as to not accidentally collide with anything else!
I'd need one for the CircuitPython device itself, and two for the UF2 bootloader modes (One is for the regular UF2 bootloader, and the other is for the "CDC Only" UF2 bootloader mode.
If I'm barking up the wrong tree here, just tell me where to point my next yip!
Thanks a bunch!