- Sun Feb 21, 2021 3:11 am
#223345
Hello everyone!!
I have connected two Can Shield Bus as indicated by the Sparkfun page to run the scketchs : CAN_Write_Demo , CAN_Read_Demo.
They compile well and I get "CAN Init ok" in the setup, but in loops I don't get any results
I would appreciate some link or suggestion to be able to start my first steps...
A cordial greeting
I have connected two Can Shield Bus as indicated by the Sparkfun page to run the scketchs : CAN_Write_Demo , CAN_Read_Demo.
They compile well and I get "CAN Init ok" in the setup, but in loops I don't get any results
I would appreciate some link or suggestion to be able to start my first steps...
A cordial greeting