SparkFun Forums

[adam.g]

Hi folks,

I've been trying to track down the sources of the high quiescent draw on the MicroMod Data Logging Carrier Board + Artemis Processor.

To measure the current draw of the board by itself, I was considering powering it up without a processor board installed. Would this pose any risk of damaging the board by doing so?

Cheers,
Adam

[TS-Chris]

Shouldn't hurt anything Adam.

[adam.g]

Thanks, Chris!

I had already accidentally blown up an Artemis Processor this morning (Note to self: don't measure current before having coffee), so I wanted to be sure I wasn't going to also blow up the MMDLCB!

Cheers,
Adam