how to debug multicore in a amp by openocd?

Open source ARM Debugger

Moderator: phalanx

Post Reply
hsy
Posts: 1
Joined: Fri Dec 08, 2017 7:07 pm

how to debug multicore in a amp by openocd?

Post by hsy » Fri Dec 08, 2017 7:22 pm

hello everyone , i have to debug a multicore device, that is an asymmetrical multicore design.Now, I use openocd to connect to my device, and I can occasionally stop one of the cores. But I can't stop two cores at the same time. I've tried to configure my target to a SMP in my openocd, but this doesn't work. How can I stop and debug them at the same time? I'm very grateful to all of you, if you tell me how to do it!

Post Reply