- Thu Oct 26, 2017 1:23 am
#196621
Hi, I have a problem with the Coulomb Counter. I have followed the Sparkfun tutorial https://learn.sparkfun.com/tutorials/lt ... okup-guide but when I connect it in interrupt mode to an Arduino, there is no downside to skip the interrupt .
I use an Arduino MKR1000.
I have loaded the same code that comes in the tutorial, I have solved the SJ2 and SJ3 to work at 3V3. I've looked with an oscilloscope and it always keeps signal high level any suggestions?
Thank you very much.
I use an Arduino MKR1000.
I have loaded the same code that comes in the tutorial, I have solved the SJ2 and SJ3 to work at 3V3. I've looked with an oscilloscope and it always keeps signal high level any suggestions?
Thank you very much.