LTC4150 Coulomb Counter

Have questions about a SparkFun product or board? This is the place to be.

Moderator: phalanx

Post Reply
Posts: 2
Joined: Tue Jan 31, 2017 10:05 pm

LTC4150 Coulomb Counter

Post by ldelvalleh » Thu Oct 26, 2017 1:23 am

Hi, I have a problem with the Coulomb Counter. I have followed the Sparkfun tutorial ... okup-guide but when I connect it in interrupt mode to an Arduino, there is no downside to skip the interrupt .

I use an Arduino MKR1000.

I have loaded the same code that comes in the tutorial, I have solved the SJ2 and SJ3 to work at 3V3. I've looked with an oscilloscope and it always keeps signal high level any suggestions?

Thank you very much.

Posts: 1
Joined: Fri Feb 09, 2018 3:02 am

Re: LTC4150 Coulomb Counter

Post by odanoun » Tue Feb 13, 2018 8:48 am

I had the same problem with the LTC4150, namely the INT signal was always high. Later I found out that the voltage across the SENSE+ pin was not within 60 mV of the supply voltage. In the datasheet is mentioned that for proper operation the SENSE+ pin must be whitin 60 mV of VDD for proper operation.

Post Reply