- Sat Aug 12, 2017 5:26 pm
#195825
hooked wiring up per documentation:
hooked up the four wires from new load cell
red to E+
black to E-
white to A-
green to A+
shield to shield
downloaded and installed the drivers
plugged in the board and windows 7 reports com port working on Com: 3
started a hyper terminal 9600 8 N 1
blue light flashes a few times then stays on
Terminal software reports reports:
Serial Load Cell Converter version 1.0
By SparkFun Electronics
No remote sensor found
Minimum time between reports: 488
Press x to bring up settings
Readings:
1467,-72094.78,lbs,25.62,0,
Any ideas on why I get the ERROR: No remote sensor found?
thanks Terry
hooked up the four wires from new load cell
red to E+
black to E-
white to A-
green to A+
shield to shield
downloaded and installed the drivers
plugged in the board and windows 7 reports com port working on Com: 3
started a hyper terminal 9600 8 N 1
blue light flashes a few times then stays on
Terminal software reports reports:
Serial Load Cell Converter version 1.0
By SparkFun Electronics
No remote sensor found
Minimum time between reports: 488
Press x to bring up settings
Readings:
1467,-72094.78,lbs,25.62,0,
Any ideas on why I get the ERROR: No remote sensor found?
thanks Terry