SparkFun Forums 

Where electronics enthusiasts find answers.

Questions relating to designing PCBs
By jlauj
#192458
Hello, I am quite new to this whole electronics thing. I have a 3 wire pressure gauge, and I need to measure it output signal onto Labjack U3. I have a circuit schematic of how it should look, however I am quite lost on how to start with making it though breadboard.

It is Figure 2 on this link.
https://labjack.com/support/app-notes/measuring-current

Also, the other question I have is do I have to use a shunt resistor for this?

THank you!
By FredC
#192945
Just follow the breadboard drawing for the circuit, linking one constituent at a time and always link your batteries or power supply to your circuit last. Be careful not to make any mistake.