- Thu May 14, 2015 11:48 am
#181980
Hello All,
For the last 15 years I have run a small PCB assembly service for a handful of designers in Northern California.
I started building boards by hand in High School for a Fuel Cell Research and Development company, from High School on I have always assembled SMT and THT boards for various companies in my local area.
I just recently upgraded from my single gantry Quad 3c to a much newer dual gantry Quad QSP2, I now have available assembly time.
I am wondering if it is appropriate to offer my services on this forum?
If it is appropriate, in which forum would be best? Are there costs involved with advertising services on this forum?
Are these questions already answered somewhere?
thank you for any info!
For the last 15 years I have run a small PCB assembly service for a handful of designers in Northern California.
I started building boards by hand in High School for a Fuel Cell Research and Development company, from High School on I have always assembled SMT and THT boards for various companies in my local area.
I just recently upgraded from my single gantry Quad 3c to a much newer dual gantry Quad QSP2, I now have available assembly time.
I am wondering if it is appropriate to offer my services on this forum?
If it is appropriate, in which forum would be best? Are there costs involved with advertising services on this forum?
Are these questions already answered somewhere?
thank you for any info!