- Sat Jan 10, 2015 9:58 am
#178524
I am following this instruction.. http://letsmakerobots.com/node/37243
Both RSSI LED on the two XBEE S2 USB Explorers are lit. Arduino RX is receiving about 20 bytes. But the value from pulseIn() from three of the PWM Arduino pins are still ZERO, connected to pin 6 (RSSI) of Xbee.
How can I fix it? Please advise.
Thank you,
Donald
Both RSSI LED on the two XBEE S2 USB Explorers are lit. Arduino RX is receiving about 20 bytes. But the value from pulseIn() from three of the PWM Arduino pins are still ZERO, connected to pin 6 (RSSI) of Xbee.
How can I fix it? Please advise.
Thank you,
Donald