- Sat Apr 21, 2012 12:55 pm
#143277
Hi guys,
I bought a GP1A57HRJ00F photo interrupter and now I want to connect it to my Arduino, but my problem is that I didn’t buy the breakout board (BOB-09322) which makes it hard for me to figure out how to connect this the right way to the arduino since I can’t read data sheets, and I kind of need to do it till Monday for a small project. So if one of you has one of these and maybe could show me a picture of how you connected it on a breadboard and to the Arduino, something very simple, I will be very thank full, as I am an amateur at this…
Best regards,
The Donkey
I bought a GP1A57HRJ00F photo interrupter and now I want to connect it to my Arduino, but my problem is that I didn’t buy the breakout board (BOB-09322) which makes it hard for me to figure out how to connect this the right way to the arduino since I can’t read data sheets, and I kind of need to do it till Monday for a small project. So if one of you has one of these and maybe could show me a picture of how you connected it on a breadboard and to the Arduino, something very simple, I will be very thank full, as I am an amateur at this…
Best regards,
The Donkey