- Fri Dec 07, 2012 5:19 am
#152908
i have thermals on by default as usual...
However, the thermal takes away virtually all the connector copper - i am left with an incredibly thin track connection the pad out to the ground plane. See photo attached.
This is a 1206 LED shown.
Tried and tried but i can't figure out how to get it to do "normal" size connections (it used to work fine on other boards I've done).
Any ideas...?
Thanks,
Paul.
i have a polygon on my board with a pour for a ground plane as usual...
i have thermals on by default as usual...
However, the thermal takes away virtually all the connector copper - i am left with an incredibly thin track connection the pad out to the ground plane. See photo attached.
This is a 1206 LED shown.
Tried and tried but i can't figure out how to get it to do "normal" size connections (it used to work fine on other boards I've done).
Any ideas...?
Thanks,
Paul.
You do not have the required permissions to view the files attached to this post.