SparkFun Forums 

Where electronics enthusiasts find answers.

Discussions on how to get your MSP JTAG programmer up and running.
By amiire
#192101
Hello !
I have a ''Logomatic c V2 - Serial SD''.I wish to know what language to use for program ?
thanks
By Valen
#192115
Have you looked at the links in the documents section of the product page? Then you would have found the hookup guide. Which explains which commands to store in a config file to make operate in a certain way.

Googling I also found this PDF from sparkfun. It looks like the Hookup-guide: https://www.sparkfun.com/products/12772

If you wish to change the program that it is running then you can write your program in C/C++. But you'll need to find a development environment for that chip, arm-based LPC2148. Here is another Sparkfun tutorial that talks about it.

https://www.sparkfun.com/tutorials/94

I never did this or owned it so I can't help further.