program language

Discussions on how to get your MSP JTAG programmer up and running.

Moderator: phalanx

Post Reply
amiire
Posts: 2
Joined: Thu Oct 20, 2016 4:30 am

program language

Post by amiire » Thu Oct 20, 2016 5:28 am

Hello !
I have a ''Logomatic c V2 - Serial SD''.I wish to know what language to use for program ?
thanks

Valen
Support Volunteer
Posts: 1628
Joined: Wed Dec 22, 2010 2:05 am

Re: program language

Post by Valen » Fri Oct 21, 2016 8:34 am

Have you looked at the links in the documents section of the product page? Then you would have found the hookup guide. Which explains which commands to store in a config file to make operate in a certain way.

Googling I also found this PDF from sparkfun. It looks like the Hookup-guide: https://www.sparkfun.com/products/12772

If you wish to change the program that it is running then you can write your program in C/C++. But you'll need to find a development environment for that chip, arm-based LPC2148. Here is another Sparkfun tutorial that talks about it.

https://www.sparkfun.com/tutorials/94

I never did this or owned it so I can't help further.

amiire
Posts: 2
Joined: Thu Oct 20, 2016 4:30 am

Re: program language

Post by amiire » Fri Oct 21, 2016 8:55 am

It's already good Valen.Thank you !

Post Reply