MSP-JTAG-TINY and Code Composer Studio 5 Problems

Discussions on how to get your MSP JTAG programmer up and running.

Moderator: phalanx

Post Reply
zaleksa
Posts: 1
Joined: Thu Dec 29, 2011 6:04 am

MSP-JTAG-TINY and Code Composer Studio 5 Problems

Post by zaleksa » Thu Dec 29, 2011 6:32 am

Hi,

I'm using Code Composer Studio 5 with Windows 7 Home Basic operating system.

I have Olimex MSP430 JTAG Tiny programmer and I followed instructions from their website how to install drivers and set CCS to work with it.
(http://www.olimex.com/dev/pdf/MSP430/MS ... 0CCSv4.pdf)

I have success to erase target, load new program, run it, debug it, but when I close debug session, CCS5 pops up following messages:

ccstudio.exe has stopped working
Windows is checking for a solution to the problem...

ccstuido.exe has stopped working...
A problem caused the program to stop working correctly.
Windows will close the program and notify you if a solution is available.
Close Program

I can only click to Close Program and it really closes.

I assume that the msp430 dll driver for Olimex JTAG Tiny might be old for CCS5, but it probably works OK with CCS4. Am I right?

Is there new Olimex msp430 dll driver for CCS5?

I also have Texas Instruments MSP-FETR430UIF JTAG programmer and there is no problem with it. Of course, I use original msp430 dll files from CCS5 with this JTAG.

Thanks in advance,

Aleksandar

Post Reply