SparkFun Forums 

Where electronics enthusiasts find answers.

Discussions on how to get your MSP JTAG programmer up and running.
By acestu
#122939
Hi I am a student and new to all this, i have a TI ads1232REF board and I have soldered a 2 x 7 pin header to the edge of the board to use with the olimex jtag programmer, now when I click read the olimex software reads the MSP430F449 onboard chip, however when I try to save the file it says cannot save file, could anybody shed some light on this please...

thanks in advance
Acestu