SparkFun Forums 

Where electronics enthusiasts find answers.

Problem using MSPGCC-JTAG with Olimex JTAG-TINY USB

Discussions on how to get your MSP JTAG programmer up and running.

Problem using MSPGCC-JTAG with Olimex JTAG-TINY USB

By Will_i_am
-  Thu Feb 23, 2006 6:54 pm #10301
I can't connect to my target (olimex board) with my USB JTAG-TINY. I followed the instructions in the "readme" that came with the driver. The readme refers however, to a MSP430.dll in the /mspgcc/bin directory which does not exist! Do I need a special version of the mspgcc-jtag tool? Where can I get it?

BTW: On a different computer I can use my parallel port JTAG, but my newwer computer doesn't have a parallel port.

Regards,
Bill

By OLIMEX
-  Sun Feb 26, 2006 11:54 am #10378
to the best of my knowledge mspgcc supports ONLY parallel port JTAG and not USB jtags
I send e-mail to mspgcc maintainers about this but without any reply so far

Tsvetan
 Return to “MSP Microcontrollers”