what happens to the I/O state during interrupts

Discussions on how to get your MSP JTAG programmer up and running.

Moderator: phalanx

Post Reply
mynameispranay
Posts: 5
Joined: Wed Apr 15, 2009 1:03 am

what happens to the I/O state during interrupts

Post by mynameispranay » Wed Apr 22, 2009 12:42 am

Hi again guys,
Well I am working with the Olimex MSP430-169LCd board based on MSP430F169 micro.

I was practicing interrupts and wanted to know what happens to the state of I/o pins when an ISR is called.


e.g if i have an LED light up at p2.0(0V= glow) and an an ISR is generated by P1.0 then what happens to the LED state?


Also , just to confirm....in ALL the low power modes the PREVIOUS I/o pin's status is unchanged?

Regards,


Pranay

User avatar
leon_heller
Support Volunteer
Posts: 5734
Joined: Sun May 01, 2005 11:20 am
Location: St. Leonards-on-Sea, E. Sussex, UK.

Post by leon_heller » Wed Apr 22, 2009 1:01 am

It remains the same.

Leon
Leon Heller
G1HSM

Post Reply