SparkFun Forums 

Where electronics enthusiasts find answers.

Discussions on how to get your MSP JTAG programmer up and running.
By naseri.m
#67673
When I am debugging , I get "Could not get target status" message when I hit run.
Single stepping works fine sometimes and sometimes gives the same
message.what is this msg?

I checked the micro it is ok! about programmer I don't know what am i doing for ?
By naz
#67793
Right click your's project file,select option-->general--->target(select which microcontroller u r using),after that compile it.

by
naz
By naseri.m
#67934
tanx for your reply,
I did that but I don't know what is the problem,do you think my programmer or the cable of JTAG programmer or something else has a problem ?