- Sat Nov 22, 2008 6:50 pm
#59778
hi,
I am using a Express card to connect a serial port to my laptop. In the device manager it shows me a COM port allocated t the card.
I have the following queries:
It shows me two COM ports
a) MSP430 FET serial port
b) Express card serial port.
In hyperterminal i select the b) port & establish a connection. Is it right?
After connection i debug the USCIA0 UARt echo code on MSP430 & run it.
When i do that i am unable to type anything if hyperterminal & if i do so it is not echoed back.
Can anyone help me how to go about this in hyperterminal or MATLAB.
Thanks in advance
Sid
I am using a Express card to connect a serial port to my laptop. In the device manager it shows me a COM port allocated t the card.
I have the following queries:
It shows me two COM ports
a) MSP430 FET serial port
b) Express card serial port.
In hyperterminal i select the b) port & establish a connection. Is it right?
After connection i debug the USCIA0 UARt echo code on MSP430 & run it.
When i do that i am unable to type anything if hyperterminal & if i do so it is not echoed back.
Can anyone help me how to go about this in hyperterminal or MATLAB.
Thanks in advance
Sid