- Fri Oct 24, 2008 6:50 pm
#57719
Hello
Newb here, as you are about to see...
Dumb question, but, how do you actually connect the 2013 chip to whatever circuit you are designing it for, and apply power and ground to the chip?
I mean I understand where all of the I/O pins are, and you just connect the wires and solder for whatever you need onto the disconnect- able board; but how do you actually provide power to the board?
Thanks for your time
Newb here, as you are about to see...
Dumb question, but, how do you actually connect the 2013 chip to whatever circuit you are designing it for, and apply power and ground to the chip?
I mean I understand where all of the I/O pins are, and you just connect the wires and solder for whatever you need onto the disconnect- able board; but how do you actually provide power to the board?
Thanks for your time